Applying the vinyl stickers is easy. Just follow the simple directions below.
When you're done, click here
to return to the cutout sticker product page.
 1.
Clean and dry the surface you plan on placing the sticker. Ensure that
all moisture is removed. Once applied, water and the elements should not
harm the sticker for at least three years. |
 2.
Peel off the top layer of paper covering with the sticker. The vinyl
sticker should remain attached to the top layer of paper, leaving a blank
backing strip to throw away. |
 3.
Ensure your sticker is level, and in the location you want, and apply it
like you would a normal sticker. Place it fully, vinyl side down, onto that
clean smooth surface. |
 4.
Seal the sticker, rubbing it hard with your thumb or the back of a spoon
or the edge of a credit card to ensure it is properly stuck to the surface.
|
 5.
Grasp the corner of the paper top layer and carefully peel it away from
the vinyl cut-out sticker. This should be relatively easy. If any of the
vinyl comes up with the backing, flatten the entire sticker out against
the surface again and press firmly along the vinyl, then attempt again. |
 6.
Show off your finished sticker with pride! If the vinyl gets dirty, simply
wipe it clean with a damp cloth. |
| 
| 